GO013

Tool kit for maintenance intervention on the drive shaft. Especially for vehicles with high fitting accuracy of the wedge taper profile of the drive shaft in relation to the wheel hub wedge taper profile.

• 10 tension sleeves and 2 tension bolts ensure maximum coverage of markets and models! For nut-secured (commonly used) and bolt-secured (e. g. VW/Audi) drive shafts.
• The slide hammer can be used to remove the outer drive shaft joints even when installed. Particularly important in the act of replacing the original rubber or thermoplastic sleeves.
• In order to complete the set, a 3-piece special pliers set, for the special circlips without eyelet, is included.

Functioning:

1. Pulling drive shafts into the wheel hub

2. Pulling the wheel hub after changing the wheel bearings

3. Separating the outer drive shaft joint

4. Assembling the outer drive shaft joint

5. Disassembling and assembling the circlips on drive shafts